AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White – Pack of 3)

By | August 27, 2017
AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White - Pack of 3)

With Amir Motion Sensor Lights, you can…
– Say good bye to bumping into stuff in the dark.
– Comfort kids who are afraid of the dark
– Cheaper to run than ceiling lights

Amir Motion Sensor Lights act like little “guardians”, provide automated, hands-free way to protect your homes indoors and outdoors. Light up your bedroom, stairs, hallway, closet, or entryway to your home where the light switch is just too far from the door. Don’t leave lights on needlessly running up the electric bill.

With easy installation, it mounts in seconds. No hammers, drills, or tools required. Simply use the double-sided adhesive pads or stick to any metal surface with the built-in magnet.

Note:

1. Please make sure that the anode and cathode of battery has been installed correctly.
2. Please do not install 2 lights too close from each other. The lighting may cause the other one DOES NOT work.
3. If you use Alkaline battery first and then change to zinc-manganese dry battery, the lights might not work as the zinc-manganese dry battery is shorter than the Alkaline battery.
4. The sensor light might not work if you use the infrared heater in winter. The infrared will cause failure of the sensor. However, the light will get back to work in 30 minutes after turning off the heater.

Specifications:

● 1.5v, 0.3w
● Sensitivity: 3 meter Distance
● Sensor Range: 120 degrees
● Operating temp: -20°C-40°C
● LED Qty: 6 LED
● Light color: Pure White
● LED life: 50,000 hours or more
● Mounting: Tape or Magnet
● Product Diameter: 3.15 in
● Thickness: 0.87 in

Package includes:

3 x Motion Sensor LED Night Light
3 x 3M double-sided adhesive pads
1 x User Manual

Seller Warranty Policy:

● 45-Day Money Back Guarantee
● 12-Month Replacement Warranty
● 7/24 Online Customer Service
● Lifetime Support Guarantee

GCID: AMIR

  • Super-bright LED Bulbs – Up to 20 Lumen output, 6 pcs super bright SMD 2835 LED; bright enough to make sure you never stumble in the dark
  • PIR Motion & Light Sensor – Auto-on within 10 feet, auto-off after 15 seconds of no motion detected helps prolong battery life. It will turn on only when it is dark and when motion is detected
  • Easy Installation – Simple to install, no hard-wiring. With 3M adhesive pads and built-in magnet, you can stick on anywhere you like
  • Battery Operated – Powered by 3PCS AAA batteries (not included) for coreless installation. To provide you with illumination in areas that have limited or no access to electricity
  • Note: This light can only be turned on in darkness environment. And the light of one may cause the other, so please DO NOT install 2 lights too close, otherwise, they will DOES NOT WORK! And Please DO NOT install this light in high temperature place, otherwise, high temperatures will affect the adhesive strip, and then the light will slide easily!!

AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White – Pack of 3) – Buy now at Amazon.com

List Price: $ 32.99

Price:

3 thoughts on “AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White – Pack of 3)

  1. T. Wear
    194 of 201 people found the following review helpful
    4.0 out of 5 stars
    Light sensor workaround, January 1, 2017
    By 
    T. Wear (Seattle) –

    Verified Purchase(What’s this?)
    This review is from: AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White – Pack of 3) (Tools & Home Improvement)
    These, like other similar wireless LED lights, had one big flaw that made them useless for me. (And I think for some other people as well.) They are fine in total darkness, but if you want them to light up a dim, but not totally dark area, they won’t turn on because of the light sensor. That makes them not only useless as an auxiliary light source, but also when grouped — since if one is on the light sensor of the other(s) prevents them from turning on.

    SOLUTION: Remove the light sensor. Please see the photos attached. Not actually that hard to do if you’re careful and don’t mind that it probably invalidates the warranty since you are essentially breaking part of it. Also be sure that’s what you want — it really will go on every time is senses motion, so be sure it’s inside a closet or other place where just passing by in the distance won’t set it off.

    Photo 1: with the back plate removed to access the batteries, there are three small Phillips screws. Remove those and carefully (there are wires) separate the back section which holds the batteries and circuits from the front section which is the case and diffuser.
    Photo 2: On the circuit board you will see two sensors. The larger one is the motion sensor so leave that alone. (the dome cover may fall off, don’t worry, it goes back on fine) the smaller sensor, seen here in the grip of the pliers, is the light sensor. Carefully so as not to damage the rest of the board, but with some force because it’s on a couple solid wires, just break off the light sensor.
    Then just put everything back together.
    Now you have a light that is motion sensitive but not light sensitive. Again, note that this will need to go somewhere that it won’t be constantly going on every time you pass unless that’s what you want. It works great for me inside a closet that has a door, and in an under stairs storage area that also has a door.

    ALTERNATE SOLUTION: If you want brighter light and don’t mind spending considerably more, this Mr. Beams light is actually designed to allow you to easily defeat the light sensor. It’s also really bright — I got one just today and love it so far! https://www.amazon.com/Mr-Beams-MB990-WHT-02-00-Wireless-Battery/dp/B01IKQDKAM

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  2. Tyler Haas
    73 of 74 people found the following review helpful
    5.0 out of 5 stars
    Disabled light sensor – now they’re great!, April 22, 2017
    By 
    Tyler Haas (Wisconsin) –

    Verified Purchase(What’s this?)
    Bought these to use as cupboard lights. At first, they didn’t work the way I wanted because the light sensor would prevent them from going on. Even in a fairly dark room they would not go on. So, as another review suggested, I disabled the light sensor so it would go on even in light rooms when motion was detected. Except instead of breaking off the light sensor, I simply covered it with black electrical tape. Now they work great!

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

  3. Steve from MA
    37 of 37 people found the following review helpful
    3.0 out of 5 stars
    Using them as a nightlight…, June 29, 2017
    By 
    Steve from MA (MetroWest MA) –

    Verified Purchase(What’s this?)
    This review is from: AMIR Motion Sensor Light, Cordless Battery-Powered LED Night Light, Stick-anywhere Closet Lights Stair Lights, Safe Lights for Hallway, Bathroom, Bedroom, Kitchen, etc. (White – Pack of 3) (Tools & Home Improvement)
    Another update. The seller continues to contact me asking me to delete my review or rate the product higher. They’ve even given me a refund which I never asked for and even wrote to them to say I did not expect this. My review is my honest opinion of a product I purchased. It’s a fine product, not perfect for my needs and hence my review. I will not respond to any more of their emails or delete my review. It’s a shame that on Amazon, anything less than 4 stars is considered the kiss of death. It shouldn’t be. It should draw the viewer to look closer at what got the less than perfect score. All products get some low scores and we buy them anyway because as purchases we are capable of reading reviews and judging the information in them. I hope my review is useful. It’s not, I feel mean or misleading. It is my experience with the product. Period.

    This is an updated review.
    I use these as night lights. Specifically, I have two of these in the bathroom. They have the appropriate sensitivity to motion. The light is a bit brighter than I would like for a nightlight, but we’ve adjusted to this. Half the light would be fine for this purpose actually which would give longer battery life (no complaint about battery life. We haven’t had them long enough to know what this is yet). I like the magnetic feature which I use in one location. For the other location I used a 3M Command Strip (not included) which works nicely.

    What would get me to give this 4 or 5 stars: 1) The ability to disable some of the LEDs to reduce the light. 2) The ability to adjust the on time of the lights.

    Prior review (2 stars)
    I am debating keeping these. I am using these as nightlights in bathrooms that do not have outlets but they stay on such a short time, they may simply not be useful for the task. If they had a way to program the on time, they could be perfect.

    Help other customers find the most helpful reviews 

    Was this review helpful to you? Yes
    No

Leave a Reply